Really dresses up those ugly fog light covers and the front. Needed help with install. Getting to old for the floor time.

Not an easy install but the excellent looks and fair price make the work worthwhile. I lost a clip that attaches to the frame with a bolt. Be careful to account for the clips when removing the old piece. Looks terrific.

Nice addition, but installation was a bit difficult. Upper holes do not line up.

Nice piece. Nothing but compliments from friends. Had no issues installing this piece. Recommend if you get this you go ahead and install the fog lights at the same time to avoid having to remove it later and possibly scratching.

looks very good with fog lights that I put on at same time. hard hard time fitting in place.

Nice piece but installation was a bit of a pain. I have a 7" fender extension and this unit has to be tipped out at the bottom to get the upper tabs into place. It hits the extension and you have to finegle it a bit to get it in. Once in place, you have to move from left to right to get the tabs into the rearward position behind the fairing tabs. Before you do all of this, you should remove the bolt up clips from your stock cowl and install them on this unit. I didn't and had to do it twice. Once in (with the clips)the bolt up goes fairly well. NOTE! All the bolt are not the same! The two upper bolts are longer and have a longer shoulder on them. One more nice touch that the manufacturer could have incorporated would have been two hole located in front of the adjuster screws for the fog lights. Then you would not have to remove it to adjust your fog lamps......no instructions, four stars.

Just installed this with the show crome blue fog lamps, both were easy to install. I did watch steve's vidio and that made it simple.... Looks great and yes I did remember to transfer over the slide on nuts... Very happy with the results...

Looks great after installed, gave me the fits trying to fit though.

Looks Great! Chrome plastic and like the previous reviewer said, DON'T FORGET the metal clips that are attached to the original cowl. Line-up was a bit difficult with the new driving lights that I installed.

Installed this with the fog lights. Just remember when you remove the OEM cowl don't forget to take the threaded metal clips off so you can use them on the new cowl. The instructions say nothing about this. I found out the hard way. Other than that turned out just the way I had expected. GREAT.

Made the bike look even better.

looks good easy to install took about 20 minutes.

Excellent, beautiful, easy to install.

Looks great. Was easy to install, no problems.

Fits and looks great at a cheaper price than the hondaline version. Finishes off the front well.

Replaced the OEM front cowl with ease. Looks great and it's a better buy than the individual chrome cowl fog light covers.

Excellent product, so much more "attractive" than the stock grey effort. Also added chrome timing cover to finish the job off. Fender extender is on the way to protect my investment. Highly recommended.

Yup, for $85 bucks this is one of the best ways to add some chrome look. Get RID of that stupid battleship gray and add this. While your at it, add the fog lights and the timing cover.

No problems with installation, and the chrome finish really adds "pop" to the bike's look!

Its a great looking piece. I added the chrome timing cover the fog lights and the chrome mud flap same time. Like others said here too, Those holes are sometimes harder to line up and using the Dremel to cut out the fog light holes works perfect.