I bought the arm rest only. Installed in less then 20 minutes. No drilling or cutting required. High quality and appear to be very strong. My wife says they are comfortable, but wishes the pads were a little further back.

For sure 5 stars, 6 if I could give it. I am running a Utopia backrest so I only got the armrest portion. Design is good and execution is flawless. All welds are TIG and not MIG which is normaly used by cut rate manufacturers. (TIG good, MIG not so.....) I initialy looked at the ones made by that other fella but the fact that they mounted to a plastic trunk bothered me. It really bothered me when I saw a feshly installed set at a dealers and it had two large yellow stickers, one on each armrest, that essentially said look at me I'm pretty but don't lean on me because I'm fragile. (It reminded me of plastic glove compartment doors with too much in the glove compartment. (Honest, I didn't push it really hard)) Any way, I ordered the Krome Werks units. I was concerned as the pictures shown on Wingstuff give the impression that all clearances are very tight. Not so. There is at least 3/4" under the swivel to the saddlebag and it clears my rear seat heat control by at least 1/4". The bolting supplied is actually a better grade than what the Honda gnomes supplied and hey, you can open the trunk up with the arms in place! I tried putting some weight on them and I figure you would have to exceed 200 pounds before there was any problem. (I weigh 150 and they didn't give an inch) So fellow Wingers, if you want something that works, is designed well, and is well made, I would recommend these in a heartbeat.

We got just the armrests, recommended by other 1800 friends. I was a hold-out, but these are great. This was our best choice because: installation was easy, no drilling required, comfortable position, substantial feel. BEST part: Opening the boot does NOT require that you move these aside. Cool, very good looking too.

Easy installation & quality is very good but the adjustments are not good for me. I need to use the middle position but angle of the backrest does not feel good. Bending the tubes back achieves the desired feel. This the second one I have purchased. I give this four stars due to the lack of more adjustability.

Nice looking and very simple to install. I like that the passenger arm rest have a good support, but would like to see a little more adjustment to the back rest… first position is too far forward, the second works best and the third is ok but just a bit too far back for my 5’ 9” height. I also like how the back rest folds forward to allow the passenger easy access. The passenger is a little cramped but the back rest is very easy to remove and still have the passenger arm rests for the shorter trips…

Just came back from a 1200 mile trip down California PCH 1 and 101 to LA and all thou it took a few hundred miles to get used to it, I’m very glad I had it… Made the ride a whole lot more comfortable. Thou a bit expensive from the other back rests its well build and looks good…