Lights seem fine, though I have not had a chance to test them in fog conditions. Installation went okay, though the instructions are more noteworthy for their omissions than for what they include. Big Bike oughta wake up and smell the coffee! Ran into all the issues mentioned in earlier reviews. The most notable in my view is this: Removing the control panel without unplugging it from the wiring harness is (probably) impossible - and that means removing the compartment above the panel. My only comment about design is that the adjusting screws seem to have minimal effect on the aiming points of the lights. The screws need to be a different design to be really effective: should have a flange below the head on the scew so that the tab on the light will be caught between the flange and the head.

Just installed these lights on my 2008 GW. Should have watched the video, as instructions are not clear at all. Lights work well and meet my expectations.

Some comments re. installation: (1) the bolts used to mount to the engine block snap off easily if you're not careful when tightening them; (2) the left side of the engine block is slightly further back than the right side, hence the instructions to use the longer bolts and spacers on the left side ... this is not a mistake in the instructions; (3) remove the left pocket (above the switch panel) to increase your workspace when mounting the light switch; (4) although the instructions don't reference using the side bolt to mount each light, you should do so; (5) finding the 4-pin black accessory connector behing the switch panel was also the most difficult thing for me ... it's hidden in a black sleeve which also contains two white connections.

Just installed these fog lamps with the crome crowl... Very impressed with the look. I did watch Steve's vidio and that made it very simple to complete the instlation... The link is http://www.goldwingfacts.com/bikersworkshopmenu.htm
If your doing the instlation your self watch the vidio... you won't be wasting your time!

THESE LIGHTS ARE GREAT! I ADDED THESE WITH THE FRONT CHROME COWL AND CHROME TIMING COVER. THESE CHANGED THE LOOK OF MY BIKE DRAMATICALLY. THE INSTRUCTIONS ARE A JOKE!!!!!!! AFTER YOU FIGURE IT OUT; EVERYTHING INSTALLS NICELY!

First mod on I did on my wing. Instructions not very clear but after looking and reading a few times I figured it out. Install fairly easy. Overall look is great.
Lights up really well. Purchased/installed the chrome lower cowl at the same time. Loved the way the whole thing turned out.
The most difficult part was locating the OEM plug for the lights in the left side pocket.